Unplug the controller’s transformer and remove the battery.Press and hold down the , and buttons.Plug the controller’s transformer back in.Release the , and buttons. The display should now show 12:00a. m.All the memory has been cleared and the controller may now be reprogrammed. Reinstall the battery.
How do I reset my hunter X2 sprinkler?
- Turn the dial to the RUN position. …
- Press and hold the program button.
- Press and release the RESET button located inside the lower wiring compartment. …
- When the display reads the controller station count; (e.g. 14) then DONE, release the PRG button.
Why is my hunter sprinkler head not rotating?
The most common reason for a sprinkler to stop rotating is the accumulation of debris in the filter. … When in operation, water turns a small turbine in the base of the sprinkler, which drives a series of gears that cause the head to rotate. The Hunter gear drive mechanism is sealed from dirt and debris.
How do I switch programs in Hunter Pro C?
- Start with the dial in the RUN position.
- Press and hold the button. Turn the dial to the WATER DAYS position.
- Release the button.
- Use the and button to change program modes.
How do I reset my orbit timer?
Reset to Factory Default – Orbit Irrigation B-hyve Help. To reset your timer back to factory settings: Turn the timer to the OFF position by rotating the dial. Open the front panel and press the reset button for 10 seconds.
