Reset to Factory Default – Orbit Irrigation B-hyve Help. To reset your timer back to factory settings: Turn the timer to the OFF position by rotating the dial. Open the front panel and press the reset button for 10 seconds.
How do you set a rain delay orbit timer?
Twist the dial to “Auto” to program a rain delay into the Orbit timer. Push the “Rain Delay” button (located on the lower-left corner) to prevent the system from watering for a day. Push the “Rain Delay” button again to prolong watering for two days and again for three days. Push “Enter” to save the delay settings.
Why is my oscillating sprinkler not rotating?
If the water level is too low, the distribution bar on an oscillating sprinkler may be unable to move at all, or it may move very slowly to the end of the cycle, then be unable to move past the pivot that sends it back in the opposite direction. (This varies a lot between models.
Why does my sprinkler timer not work?
If your sprinklers aren’t working but the timer is on, the problem could be a fuse. … Open the sprinkler timer box to check the fuses; if any are broken, replace them. The problem could also be the sprinkler system’s antenna, which is often powered by a 9-volt battery. Replace the battery and see if that helps.Why is my orbit sprinkler not rotating?
When the water pressure is too low, an inadequate amount of water flows through the sprinkler head and it will not turn. … Damaged or broken Orbit sprinkler heads cannot be repaired and will need to be replaced.
How do I reset my orbit?
- Step 1: Make sure that the Orbit is powered ON. It needs to be ON to conduct factory reset.
- Step 2: Reset. Press & Hold the + and the – buttons together for 5 seconds. Once it’s been reset, the previously connected devices displayed on the screen will disappear.
How does the orbit sprinkler timer work?
The sprinkler timer tells each valve to open at a specified time, run for a specified time, and then close. Some sprinkler timers can be connected to smart devices which automatically calculate when and how long the system should run and shut the system off when it is raining.
How do I test my orbit sprinkler timer?
- Turn the dial to the “Auto” position and press the “Manual” key to test the valves on Easy Dial and Easy Set Orbit timers. …
- Turn the dial to the “Auto” position and move the slide switch for the desired valve up to the “Manual On” position to test valves on Orbit’s “Individual Station Slide” timers.
