How do I set the timer on my orbit 2 station

Reset to Factory Default – Orbit Irrigation B-hyve Help. To reset your timer back to factory settings: Turn the timer to the OFF position by rotating the dial. Open the front panel and press the reset button for 10 seconds. 0 of 1 found this helpful.

How do I reset my orbit hose timer?

Reset to Factory Default – Orbit Irrigation B-hyve Help. To reset your timer back to factory settings: Turn the timer to the OFF position by rotating the dial. Open the front panel and press the reset button for 10 seconds. 0 of 1 found this helpful.

How do I test my orbit sprinkler timer?

1. Turn the dial to the “Auto” position and press the “Manual” key to test the valves on Easy Dial and Easy Set Orbit timers. …
2. Turn the dial to the “Auto” position and move the slide switch for the desired valve up to the “Manual On” position to test valves on Orbit’s “Individual Station Slide” timers.

Why does my sprinkler timer not work?

If your sprinklers aren’t working but the timer is on, the problem could be a fuse. … Open the sprinkler timer box to check the fuses; if any are broken, replace them. The problem could also be the sprinkler system’s antenna, which is often powered by a 9-volt battery. Replace the battery and see if that helps.

How do you program a orbit 6 sprinkler timer?

1. Turn the dial to “Cycle Start Times.”
2. Press the “+” or “-” to set the start time.
3. Press “Enter” to confirm the start time.
4. Press “Next” to set the start time for each additional program, following the same procedure.

How do automatic water timers work?

A water flow timer using a ball valve contains an electric motor with gears to stop or start the water flow by turning a perforated ball within the water flow line. The gearbox in a ball valve timer makes a rumbling sound when actuated.

How do you set a rain delay orbit timer?

Twist the dial to “Auto” to program a rain delay into the Orbit timer. Push the “Rain Delay” button (located on the lower-left corner) to prevent the system from watering for a day. Push the “Rain Delay” button again to prolong watering for two days and again for three days. Push “Enter” to save the delay settings.

How do I fix my orbit sprinkler timer?

1. Turn On the program settings. Now, select the option of watering.
2. Turn on the Auto mode.
3. Set the Station Delay settings.
4. Lastly, press the Reset button, and here goes your fixing.

How do water sprinkler timers work?

An automatic sprinkler valve controls the flow of water from the mainline to each zone. … The sprinkler wire connects each automatic valve to the sprinkler timer or controller. The sprinkler timer tells each valve to open at a specified time, run for a specified time, and then close.

Where is my sprinkler timer located?

Often the valves are located inside one or more in-ground valve boxes. The tops of these boxes will be at ground level, and these, too, are usually fairly easy to spot and access. The valve box, or sometimes the valves themselves, are sometimes buried underground.

Article first time published on

Why does my orbit sprinkler system run twice?

A common reason why a program is repeating is that you have a second start time set. The start times control the exact time your ESP-Me timer will begin to water and they also control how many times a day your timer will water. The ESP-Me allows you to set up to 6 start times per program.