Insert functioning key & turn 1/4 turn clockwise.Insert & remove the SmartKey learn tool. Remove functioning key.Insert new key & turn 1/2 turn counter-clockwise. Done. Your lock is now re-keyed! “”
How do I factory reset my Kwikset Smart Code?
- Open your door.
- Extend the latch bolt.
- Slide up the cover to open the back of your lock, exposing the buttons beneath.
- Push and hold the reset button for 10 seconds, until the lock beeps.
- The light ring will flash red, then spin amber.
- The lock has now been restored and is ready to be set up again.
How do I factory reset my Kwikset 910?
- Remove the batteries.
- Press and hold the lock button on the keypad.
- Place the batteries back in (while still holding the button)
- The lock will beep three times over the course of 15 seconds or so. After the 3rd beep release the button.
What is the master code for Kwikset?
The default Mastercode is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open.How do I reset my Kwikset 910 lock code?
Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. Press the Program button once more. When the LED flashes green and you hear one beep, the lock has been reset.
How do you figure out the combination to a 4 digit lock?
- Look for your combination number. …
- Set the first digit of the combination. …
- Set the second digit of the combination. …
- Set the third digit of the combination. …
- Set the fourth digit of the combination. …
- Pull the shackle to unlock.
How do you reset a locked 4 digit lock?
- Pull up the shackle to open the lock.
- Rotate the shackle 90° counterclockwise and press all the way down.
- Hold down the shackle and set your own combination by turning dials.
- Turn the shackle back as normal. The setting is now complete.
What is every possible 4 digit code?
There are 10,000 possible combinations that the digits 0-9 can be arranged into to form a four-digit code.How do you reset a 4 digit Lockwood combination lock?
Pull out and rotate shackle 180°, so that the shackle aligns with the slot. 3. Depress the shackle into the slot, hold down, set your new combination, release the shackle.
How do you reset a combination lock without the code?To open combination locks without a code, start by pulling up on the dial and turning it clockwise until you hear the lock click. Then, check what number you’re at, add 5 to that number, and write it down. Next, set the dial to that number and turn it counterclockwise until you hear it click again.
Article first time published on
